WEN 21C Engraver 13Watt - Manual (Page 3)

Installing an engraver tip
WARNING: Disconnect the engraver from the power supply before making any
adjustments or maintenance procedures.
1. Loosen the tip release screw by turning it counterclockwise with the included Allen wrench.
2. To fit the new engraving tip, insert the tip through the center of the hole of the engraver,
ensuring the tip fully enters the housing. A new tip should protrude from the end of the
housing by approximately 8.5mm.
3. Tighten the tip release screw fully by rotating in a clockwise direction.
Operation
Warning: Thoroughly read and understand all instructions before using this product.
Save this manual.
Warning: Allow time for a complete cool down of the tool after operating the tool
for 30 minutes on full load.
.
WARNING: Disconnect the engraver from the power supply before making any
adjustments or performing any maintenance
The engraver can be used to permanently mark metal, glass, plastic, wood, ceramics and much
more.
1. Before using the engraver you must ensure the engraving tip is installed.
2. Connect the engraver plug to the power supply. While firmly holding the engraver, push up
on the on/off switch with your thumb.
NOTE: To turn the tool on, press the ON/OFF Switch to the (I) position. To turn the tool off,
push the ON/OFF Switch to the (O) position.
3. Hold the engraver at an angle, like you would hold a pen. Do not press down hard while
engraving, use light pressure while guiding the point over the work to be completed.
Adjusting the depth of engraving
1. The stroke adjustment dial located on the side of the engraver controls the stroke length and
therefore the depth of engraving.
2. For a fine mark turn the stroke adjustment dial counterclockwise to position ‘1’.
3. For a deeper, thicker mark turn the stroke adjustment dial clockwise to position ‘5’.
NOTE: It is recommended that you practice on scrap material before you start.