Chisel sharpening port – Work Sharp WS2000 Tool Sharpener & Grinder User Guide User Manual
Page 6
10
www.worksharptools.com
www.worksharptools.com
11
2
Unpacking and Assembling
1.
Carefully remove the tool and the
accessories kit from the box.
2
.
The WORK SHARP™ WS2000
includes:
•
WORK SHARP™ WS2000 unit
•
Edge-Vision™ slotted wheel
(fig. 2-1)
•
Top tool rest
(fig. 2-2)
•
Abrasives kit including standard
and slotted adhesive-backed
abrasives
(fig. 2-3)
•
User’s guide
3.
Remove all packing materials and
store in case you ever need to return
the unit for servicing.
4.
Visually inspect your tool for poten-
tial damage incurred during ship-
ment. If there is damage, call 800-
597-6170 to speak to a Customer
Service Representative.
5.
Your WORK SHARP™ WS2000’s
Edge-Vision™ slotted see-through
wheel (fig. 2-1) can be used two
ways. Use it with the Edge-Vision
™
Underside Port for sharpening small
carving and lathe tools, screwdrivers,
and other general purpose grinding
tasks. You can also use it with solid
abrasive media for fast and easy top-
side sharpening of putty knives, axes,
and other bladed tools.
6.
To apply the 150mm adhesive-
backed abrasive disks, a clean work
environment is critical. Peel the back-
ing film off the abrasive disk. Handle
the abrasive disk by the outer edges,
being careful not to get any contami-
nants on the adhesive backing. Flex
the paper into a “U”
(fig. 2-4) shape
so the center of the abrasive is cen-
tered on the wheel. Slowly flatten out
the abrasive from the center working
toward the outer edge of the wheel.
Adhere the slotted abrasive in the
same manner outlined above. Be sure
all the slots in the abrasive properly
align with the slots in the wheel sur-
face. This will ensure proper perfor-
mance of the Edge-Vision™ slotted
wheel during use.
Fig. 2-1
Edge-Vision
TM
Slotted Wheel
Fig. 2-2
Top Tool Rest
Fig. 2-3
Abrasives Kit
(standard and slotted)
Fig. 2-4
7.
To install your
top tool rest,
slide the top
tool rest into
the T-slots on
the top of the
unit. Locate the
desired height,
then gently snug
the two thumb
screws. Do not
over tighten the thumbscrews, as you
can potentially stress and/or damage
the T-slots in the top casting.
8.
Mount the grinding wheel to the
wheel hub and secure the wheel with
the top knob.
9.
Your tool is now ready for use!
3
Sharpening Guide
Read all safety warnings before operat-
ing this tool.
Chisel Sharpening
Port—
For chisels and
plane blades up to 1
/
"
wide
STEP 1
Mount the grinding wheel onto the unit
with coarse side up.
STEP 2
Flatten tool back on topside of abrasive
wheel. Lay tool down heel first onto wheel.
After flattening tool back, flip grinding
wheel over so coarse abrasive is now face
down for bevel grinding.
Chisel Sharpening Port