Catskill Craftsmen 1580 - Manual (Page 10)

STEP 9
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut
1 3/4” Phillips Flat Head Bolt
4 Used
in this step
10-24 Hex Nut
4 Used
in this step
BE SURE TO USE THE
CORRECT BRACE AND
THAT THE HOLES
ALONG THE EDGE FACE
THE BOTTOM OF THE
CART - THESE WILL BE
USED TO ATTACH THE
STEMWARE HOLDERS.
A. Take the top front brace with the holes facing the bottom of the cart,
insert the pins in the brace ends into the slots on the inside of the
front legs and slide down until the brace rests on the bottom
of the drawer front.
B. Twist drawer dowel into the 1/2” dia.
hole on the inside of the front brace.
C. BEFORE securing brace with
1-3/4” machine screws/hex nuts,
raise brace approximately 1/8”
before tightening ( or use a
couple of dull kitchen knives
as spacers between the brace
and the top edge of the
drawer front. ) This will allow
the drawer to open easily
when unit is uprighted.
D. Take the bottom front brace,
insert the pins in the brace ends
into the slots on the inside of the
front legs and slide down until
the brace is flush with the bottom
of the side panels. Secure the
bottom brace with 1-3/4” machine
screws/hex nuts.