Step 3 – Catskill Craftsmen 1580 User Manual
Page 5
STEP 3
1 3/4 Machine Screw
Nut
1 1/4 Screw
Towel Bar
Towel Bar Post
A. Attach the Towel bars to the side panels
using 1-1/4 #8 screws.
B. Lay back panel flat on a smooth surface with holes up.
C. Attach side panels to the back panel with 1-3/4 machine
screws (bolts) and hex nuts. After inserting bolts thru the
holes in the side panels, thru the holes in the long edges
of the back panel, place a hex nut on the tip of your finger,
align nut with bolt and tighten. MAKE SURE THE GLIDES
EXTEND OUT THE FRONT SIDE OF THE CART.
D. Look ahead to step 5 which shows side panels
attached to back panel.
IMPORTANT NOTE:
Back panel is flush with
bottom of side panels. Back
panel is 1 shorter than side
panels which leaves gap for
drop leaf supports at the top.
1 3/4 Phillips Flat Head Bolt
4 Used
in this step
10-24 Hex Nut
4 Used
in this step
4 Used
in this step
1-1/4 Phillips Flat Head #8 Screw
REMEMBER TO MAKE SURE
THE GLIDES EXTEND OUT THE
FRONT SIDE OF THE CART.