Catskill Craftsmen 1580 - Manual (Page 8)

STEP 6
A. Attach the drawer back to the drawer sides with
two 1-1/2” #8 screws. The drawer back leaves a 1”
gap at the top to allow drop leaf support clearance.
Make sure parts are aligned as in illustration 6A.
B. Insert drawer bottom into the slots in the drawer
sides, best side to inside of drawer. Slide down
until seated in the slot in the drawer back.
See illustration 6B.
C. Screw the cam posts into the two outside holes
on the inside face of the drawer front until seated.
Only 3/8” of this post goes into the wood, leaving
the 4 guide rings/head exposed. See illustration 6C.
D. Insert the posts into holes in the drawer side
until seated against the front ends of the drawer
sides. Insert cams so that slot in the cam fits over
the post and turn with Phillips screwdriver until
seated. Don’t over-torque! See illustration 6D.
E. Attach drawer handle with the two handle
screws.
Below line in wood
Cam Posts
2 used in this step
ILLUSTRATION 6C
1 1/2” Phillips Flat Head #8 Screw
2 used
in this step
Cam
2 used
in this step
1” Truss Head Machine Screw
2 used
in this step
ILLUSTRATION 6A
ILLUSTRATION 6B
ILLUSTRATION 6C