Step 4 – Catskill Craftsmen 1580 User Manual
Page 6
Advertising
STEP 4
5/8 Phillips Flat Head #8 Screw
20 Used in this step
Assemble the table top by placing the top and
the drop leaf upside down on a smooth flat
surface. Install hinges using 5/8 #8 screws. The
longer part of the hinge goes on the drop leaf
with the short part on the cart top. Fasten the
drop leaf supports using 5/8 #8 screws.
IMPORTANT NOTE:
STEPS 4 - 10 WILL BE ACCOMPLISHED WITH THE
UNIT TOP UPSIDE DOWN ( INVERTED ), BUILDING
UPWARD TOWARD THE BOTTOM/CASTER END!
BE CAREFUL AS PART DESCRIPTIONS ARE BASED
ON AN UPRIGHT, COMPLETED UNIT!
Invert table top on a smooth flat surface and
make a large (X) mark over each of the pilot
holes in the bottom. Make marks about
1 1/2 long. These marks will help you align
the cabinet with the pilot holes in step 5.
Advertising