Catskill Craftsmen 15445 - Manual (Page 4)

STEP 1
A. Attach the Drawer Back to the Drawer
Sides with four 1 1/4” #8 screws. There are
left and right sides. Make sure the slots that
run the length of the Slides are aligned with
the slot in the Drawer Back to accept the
Drawer Bottom.
B. Slide in Drawer Bottom, best side up,
to inside of drawer.
C. Screw the cam posts into the two outside
holes on the inside face of the drawer front
until seated. Only 3/8” of this post goes into
the wood, leaving the 4 larger guide
rings/head exposed. See illustration 1C.
Visit our website www.catskillcraftsmen.com
for a video on cams.
D. Insert the posts into holes in the drawer
sides until seated against the front ends of
the drawer sides. Insert cams so that the
arrow on the outside face of the cam points
to the post. The slot in the cam fits over the
post. Turn with Phillips screwdriver until
seated. Don’t over-torque!! See Illustration
1C. See our video online at
www.catskillcraftsmen.com
E. Attach the drawer handle with one 7/8”
Truss head machine screws.
F. Attach the drawer glides (left and right) to
the Drawer Sides using two 5/8” #5 screws
per side. (packed separately) Wheels go
toward Drawer Back and are up. Glides are
flush with front ends of drawer sides and
stick out about 3/4” in back.
FOR TIPS ON HOW THE CAM SYSTEM
WORKS SEE LAST PAGE or visit us online
at www.catskillcraftsmen.com and view our
video.
Drawer Assembly
Illustration 1A
Illustration 1B
Illustration 1C
Illustration 1D