Catskill Craftsmen 15445 - Manual (Page 7)

STEP 5
Back Assembly
Illustration 5
A. Lay the left side unit as in
illustration 5 and attach the top Back
Brace using the bastion post/pins. Now
fit the Back Panel between the Bottom
Back Brace and Middle Back Brace
using 3/4” steel pins, and then attach it
to the side unit using bastion posts, pins,
barrel nuts and set screws.
See illustration 5
B. Attach the Left Cabinet Glide to
the Glide Support Brace with 5/8” #7 flat
head screws. The glides look almost alike
however, the right glide (as you face the
cart) has a rolled lip at the top of the glide
that keeps the drawer glide wheel in
place. Line up the holes in the the
glides so that the end with the wheel
comes flush with the edge of the leg.
STEP 6
Front Assembly
A. Tap 1 1/2” pins into the ends of the
doors and fit both doors between the Middle
Front Brace and Bottom Front Brace using
pins as shown in illustration 5 but put
washers on pins on the bottom of the doors.
B. Now attach the braces to
the side unit using bastion posts/pins as
in illustration 5/6.
Washer
Washer
Illustration 6
Inside View