Catskill Craftsmen 61532 - Manual (Page 11)

STEP 14
A. Upright unit. Take bottom shelf
(no edge banding) and place it on
the set of back pins. Close doors
and shelf will drop into place.
B. Decide on position of middle
shelf, then tap two 1” pins into
each side panel, making sure
the pins on both sides are in
the same relative position.
To remove a pin, use pliers
or claw hammer.
C. Place middle shelf,
edge banding out, on pins.
D. Insert drawer.
Note: If the top edge of the
drawer front hits the underside
of the cart top or the top edge
of the top front brace, loosen
the machine screws in the top
front brace a little and adjust
brace down until drawer opens/
closes freely - check to make
sure doors open/close freely.
E. Re-tighten all bolts/nuts.
Tap wooden disks into sides.
ILLUSTRATION 15
Edge
Banding
STEP 15
Assemble Backsplash
Attach the backsplash to the back
edge of the table top with 1 1/4” #8
screws in three places as shown.
3 used
in this step
1 1/4” #8 PHILLIPS FLAT HEAD SCREW