Catskill Craftsmen 61532 - Manual (Page 4)

7/8” Truss Head Machine Screw
STEP 1
A. Tap/insert ONE 1 1/2” pin
into each end of both doors.
DON’T OVERDRIVE PINS!
Pins should stick up about 1/2”
when seated.
B. Attach the magnet plates
(may be stuck to magnet!) with
the small flat head screw to the
top of the right door. Bumps
toward wood.
C. Attach door handles with
four 7/8” truss head machine
screws.
STEP 2
Assemble Spice Rack
Insert retainer
rods into holes
Fasten Shelves with
1 1/4” Phillips Flat Head
#8 Screw (Bronze)
Pilot holes in shelves
go toward back
8 bronze used
in this step
1 1/4” Phillips Flat Head #8 Screw
1 3/4” Phillips Flat Head Bolt (8)
HARDWARE 51524
Magnet Pack
7/8” Truss Head Machine Screw (6)
3/4” Long 3/16” DIA. Steel Pin (4)
1” Long 3/16” DIA. Steel Pin (8)
1 1/2” Long 3/16 DIA. Steel Pin (4)
Cam (2)
10-24 Hex Nut (8)
Nickel Handle (3)
Caster Socket (4)
Locking Wheel Caster (2) Non-Locking Wheel Caster (2) Towel Bar (1)
5/8” #6 Pan Head
Screw (2)
1/2” Phillips Flat Head
#4 Screw (1)
Magnet (1)
Magnet Plate (1)
14” Drawer Glide (1 Set )
Drawer
Cabinet
L-Bracket (4)
Cam Posts (2)
1 1/4” Phillips Flat Head #8 Screw (15)
5/8” Phillips Head #8 Screw (3)
Spice Rack Retainer Rods (2)
3/16” Flat Washer (6)
Towel Bar Post (2)
1” Phillips Flat Head #8 Screw (4)
5/8 Wooden Disk (8)
Note: Use the 8 Bronze screws
to assemble the spice rack
(Used on Spice Rack
& Side Handle/Towel Bar)
(Used to attach
the door spacer)
(Used to attach
the drawer front)