Catskill Craftsmen 61532 - Manual (Page 5)

STEP 3
A. Attach the drawer back to the drawer sides with four
1 1/4” #8 screws. Make sure parts are aligned
as in illustration 3A.
B. Insert drawer bottom into the slots in the drawer
sides, best side to inside of drawer. Slide down until
seated in the slot in the drawer back. See illustration 3B.
C. Screw the cam posts into the two outside holes on
the inside face of the drawer front until seated. Only
3/8” of the post goes into the wood, leaving the 4 larger
guide rings/head exposed. See illustration 3C. Visit us
at www.catskillcraftsmen.com to view our cam video.
D. Insert the posts into holes in the drawer sides until
seated against the front end of the drawer sides. Insert
cams so that slot in the cam fits over the post and turn
with Phillips screwdriver until seated. Don’t over-torque!
See illustration 3D.
E. Attach drawer handle with the two 1” Truss Head
screws. (no illustration).
F. Attach drawer glides to drawer sides using
5/8” #5 screws. See illustration 3E
ILLUSTRATION 3C
Below line in wood
Cam Posts (2)
4 used
in this step
1 1/4” Phillips Flat Head #8 Screw
2 used
in this step
7/8” Truss Head Machine Screw
2 used
in this step
Cam
4 used
in this step
5/8” Phillips Flat Head #5 Screw
ILLUSTRATION 3A
ILLUSTRATION 3B
ILLUSTRATION 3D
ILLUSTRATION 3E