Catskill Craftsmen 64024 - Manual (Page 5)

STEP 2
Attach Posts To Legs
A. There are 2 right legs and 2 left legs. Diagonal legs are the same (Example: Right Front /Left
Back). See Illustration 2 below which shows the legs paired (inside view) for the front and back panels
respectively. Notice that the position of the posts in the front legs differ from those in the back legs. This
difference will mean that there are some holes that are not used on all legs.
B. Take all 4 legs and lay out in pairs as in Illustration 2. Each pair of legs should be mirror images of
each other! Make sure the bottoms of the legs (hole in each of legs for caster is bottom) are down as
they are in the illustration.
C. On the Front Legs, posts will go into holes #1 and #5 counting down from the top. On the Back Legs,
posts will go into holes #1 and #3. On the Front Legs, hole #3 is not used. On the Back Legs, holes #4
and #5 are not used.
D. To seat posts, tap the slotted end of posts with hammer until threads just enter holes; then tighten
down (see “Tips On How The Bastion System Works” for alternative methods) until the solid shaft of the
post hits the wood, then back about 1/2 turn so that the hole in the post is perpendicular to the length
of leg/wood grain. Screw posts into all 4 legs. Double check with Illustration 2.
(A)
(B)
(B)
(B)
(B)
(A)
(A)
Posts
TOP
RIGHT LEFT
FRONT LEGS
(A)
(B)
(B)
(B)
(B)
(A)
(A)
(A)
(B)
(B)
(B)
(B)
(A)
(A)
Posts
NOT USED
Posts
TOP
LEFT RIGHT
BACK LEGS
Posts
INSIDE VIEW
(A) Thru holes
used to attach
Side Panels
(B) Pin holes
for pins that
support Side
Shelves Sets
of 2
Note: Only the post holes are used
on Back Legs Step 1.
NOT USED
NOT USED
NOT USED
Pins
Pins
Illustration 1
(A)
(B)
(B)
(B)
(B)
(A)
(A)
Illustration 2