Catskill Craftsmen 64024 - Manual (Page 6)

STEP 3
Assemble Cabinet Back
A. Take the Back Panel and the Back Legs, lay out as in illustration 3. The Back Panel cannot be installed
improperly since the top and bottom hole measurements are the same distance top to bottom.
Nut Access Holes
Nut Access Holes
Illustration 2
Illustration 2A
Inside View
Nut Access Holes
Nut Access Holes
Illustration 2
Illustration 2A
Inside View
B. Drop a Barrel Nut, open
end up, into each of the
large nut access holes in
the Back Panel. There are
small indented marks on
the lip of the open end of
the Barrel Nut. This shows
the alignment of the holes
through the sides of the
Back Panel. Continue
seating Post until Post goes
thru the sides of the Barrel
Nut and the hole in the post
can be seen through the
threaded end of the nut.
When the back panel is flush
against the inside of the leg,
the hole in the post should
be offset toward the side of
the access hole adjacent
to the post. Insert the Set
Screw and tighten down
with Phillips screwdriver. Set
Screws should thread easily.
DO NOT CROSS THREAD
OR FORCE. As you tighten
the Set Screw down, the
tip of the screw will seek
the center of the hole in the
post, thereby pulling the side
of the Barrel Nut against the
inside edge of the access
hole and toward the leg. If
the nut is loose and does
not tighten down against the
wood after the Set Screw
is tightened then you will
need to remove the leg(s)
and tighten the Bastion Post
down another 1/2 turn, then
repeat above.
C. Attach Right Leg to Back
Panel in the same manner.
Illustration 3A shows the
assembled Back Panel.
Illustration 3
Illustration 3A