Delmhorst Instrument Moisture Check - Manual (Page 10)

Copyright  2005, Delmhorst Instrument Co.
Page 10 of 29
2. You may begin taking readings by firmly pressing the back of the meter onto the
material. This will display a relative reading that ranges between 0 and 200.
TO SET THE ALARM IN BASIC SCAN MODE:
1. If you wish to set the alarm to beep after a pre-selected relative value is reached, use
the с т keys from the SCAN screen to highlight the ALARM. Press the SELECT key
to enter the alarm sub menu.
2. The default status of the alarm is “OFF.” Press the SELECT key to turn it on.
3. After the alarm is turned on, use the п р keys to scroll up or down to a higher or
lower alarm value.
4. After you have selected the alarm value, use the ò key to highlight DONE. Press
SELECT to get back to the %MC SCAN screen.
Note: Default alarm setting for SCAN mode is 300.
TO RESET THE METER TO DEFAULT SETTINGS IN BASIC MODE:
1. Use the п р keys from the BASIC main menu to highlight #4: DEFAULTS. Press
the SELECT key. The meter will display the following question:
2. Use the п р keys to answer “YES” or “NO.” If you answer “yes,” the meter will
return to factory default settings in basic mode; i.e. Species = Douglas fir, Temperature
correction = 70 F, Alarm = OFF in pin mode. In Scan mode, Alarm = “off.”