Fire-Lite IPDACT-2 - Manual (Page 42)

IPDACT-2(UD) - Configuration
III-39
Doc.DM385-I
Rev. 4.0
Teldat MIP v3 @ 29.4912 MHz (18)
S/N: 0563/01000 FF020407 0
v5.0 EU Apr 13 2007
04/20/2018 05:39:00
LAN
MAC: 0-A0-26-32-3-84 state: up
INPUT, OUTPUT
Input1:1K-TERM
Input2:1K-TERM
Output:INACT
TAMPER INPUT
state: BOX OPEN
PSTN Line
state: line cut
Reset/Phone console jumper
state: OPEN
Modem V32 daughter board
state: detected
Press any key to continue...
Option f) displays the state of the connection with the VisorALARM IP
receiver.
State: Active (4)
Press any key to continue...
Option g) displays the enabled events. To return to the menu, strike any key.
Option h) displays the IP parameters that are running in the device. If the
device has not obtained an address through DHCP, this displays the IP
address, mask and gateway configured in the “a) Generic IPDACT-UD
config
” menu. If on the other hand, IP configuration has been dynamically
obtained from a DHCP server, these parameters will be displayed together
with other parameters pertaining to the DHCP protocol: remaining time for the
obtained address value, remaining time until the next attempt to renew the
said address and the DHCP server the parameters were taken from.