GW Instek GOM-802 Programming Manual - Manual (Page 4)

DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 6 ⎯
z Ensure the same baud rate is used on the device as the one used on
PC terminal.
z Ensure the connector for the both side of cable and the internal
connected line are met the demand of the instrument.
1. No connection
2. Receive Data(RxD) (input)
3. Transmit Data(TxD) (output)
4. No connection
5. Signal Ground(GND)
6. No connection
7. No connection
8. No connection
9. No connection
Figure 1 Pin assignments of the RS232 connector on the rear panel for DB-9-D
DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 7 ⎯
Figure 2 Wiring configuration for DB9 to DB9
Computer’s Connection
A personal computer with a COM port is the essential facilities in order
to operate the Meter via RS232 interface.
The connections between the Meter and computer are as follows:
I. Connect one end of a RS232 cable to the computer.
II. Connect the other end of the cable to the RS232 port on the
Meter.
III. Turn on the Meter.
IV. Turn on the computer.
EQUIPMENT
(DB9, DTE)
COMPUTER
(DB9, DTE)
Pin2
Pin3
Pin5 Pin5
Pin3
Pin2