GW Instek GOM-802 Programming Manual - Manual (Page 9)

DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 16 ⎯
:CONFigure:SCAN:STATe<Boolean> Sets scan mode on or off.
:CONFigure:SCAN:STATe? Returns scan mode on or off.
:CONFigure: SCAN:CHANnel
<NR1> Sets the channel for scan mode.
:CONFigure: SCAN:CHANnel? Returns the channel for scan mode.
:CONFigure: SCAN:DELay <NR1> Sets the delay time for scan mode.
:CONFigure: SCAN:DELay? Returns the delay time for scan
mode.
:CONFigure: BUZZer <NR1> Sets buzzer mode.
:CONFigure: BUZZer? Returns buzzer setting.
:CONFigure:TRIGger:STATe
<Boolean> Set trigger mode on or off.
:CONFigure:TRIGger:STATe? Returns trigger mode on or off.
:READ? Returns the measured value.
:MEASure<X>? Return the sweep result of the X
group, including HI/LO/GO and
reading value.
:SHOW? Return the compare result of 100
groups.
DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 17 ⎯
z Calculation Commands
:CALCulation: LIMit:STATe? Returns Compare mode on or off.
:CALCulation: LIMit:STATe <Boolean> Sets Compare mode on or off.
:CALCulation: LIMit:LOWer?
Returns the value of the lower
limit.
:CALCulation: LIMit:LOWer <NR2> Sets the value of the lower limit.
:CALCulation: LIMit:UPPer?
Returns the value of the upper
limit.
:CALCulation: LIMit:UPPer <NR2> Sets the value of the upper limit.
:CALCulation: LIMit:NORMal? Returns the normal value.
:CALCulation: LIMit: NORMal <NR2> Sets the normal value.
:CALCulation: LIMit:FAIL? Returns the limit result.
:CALCulation:PERCent:STATe?
Returns the percentage mode on
or off.
:CALCulation: PERCent:STATe
<Boolean> Sets the percentage mode on or
off.
:CALCulation: RELation: STATe
<Boolean>
Sets REL mode on or off.
:CALCulation:RELation: STATe? Returns REL mode on or off.
:CALCulation:RELation:DATa?
Returns the reference value of
the REL mode.
:CALCulation:RELation:DATa <NR2>
Sets the reference value of the
REL mode.