GW Instek GDS-1000 Series User Manual - Manual (Page 14)

GDS-1000 Series User Manual
14
Utility key Utility Configures the Hardcopy function
(page79), shows the system status
(page71), selects the menu
language (page73), runs the self
calibration (page93), and
configures the probe
compensation signal(page94).
Help key Help Shows the Help contents on the
display (page35).
Autoset key Autoset Automatically configures the
horizontal, vertical, and trigger
settings according to the input
signal (page37).
Measure key
Measure Configures and runs automatic
measurements (page43).
Save/Recall key
Save/Recall Saves and recalls image,
waveform, or panel settings
(page74).
Hardcopy key
Hardcopy Copies image, waveform, or panel
settings to an SD card (page79).
Run/Stop key Run/Stop Runs or stops triggering (page38).
Trigger level knob
LEVE L
TRIGGER Sets the trigger level (page64).
Trigger menu key
MENU Configures the trigger settings
(page64).
Single trigger key SINGLE Selects the single trigger mode
(page71).
Trigger force key FORCE Acquires the input signal once
regardless of the trigger condition
at the time (page71).
Horizontal menu
key MENU Configures the horizontal view
(page57).