GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 92)

LCR-8000G Series User Manual
92
Set horizontal axis (Frequency)
Background The X (horizontal) axis is selectable from Voltage
and Frequency sweep.
 When Voltage sweep is selected: measurement
Frequency is fixed
 When Frequency sweep is selected:
measurement Voltage is fixed
Select Frequency 1. Press the Up/Down key and move
the cursor to Sweep.
Sweep: Drive Level
2. If necessary, press the Left/Right
key to change the sweep setting to
Frequency.
Drive Level Frequency
Set start
Frequency 3. Press the Up/Down key and move
the cursor to Start.
Start: : 20.000Hz
Use the numerical keys to enter the
starting Frequency.
Range 20Hz ~ 1MHz/5MHz/10MHz
(stop Frequency must be higher than the start
Frequency)
50Hz
Enter
1.2kHz
k Enter
Backspace All clear
Clear
If a wrong unit is entered, the value is cancelled.