KANOMAX 6710 TABmaster Capture Hood User Manual - Manual (Page 11)

4
2）The figures below are provided as a reference.
a. Use the mark ① and the stitching as a guide to ensure the hood position.
b. Make sure the hood fully wraps around the base.
3.2 Assembling the Frame (detail)
Insert one end of a support pole into its pole mount in the base as in figure ① and the other
end into the frame corner as in figure ②. For the positions of the remaining 3 poles refer to figure
③
, and repeat the steps as above.
Note：The support poles always cross in an “X” shape when the hood is assembled. To
remove the poles, simply reverse the steps.
3.3 Installing the Portable Handle
To install the handle line it up with the mounting hole as shown in step ① and ② below. Step
③ shows the handle installed.
Note：The support poles and the portable handle should be disassembled before
packing the capture hood in the carrying case to avoid damaging the case.
① ②
③
① ② ③
①