KROHNE OPTISONIC 6300 EN - Manual (Page 31)

ELECTRICAL CONNECTIONS
4
31
OPTISONIC 6300
www.krohne.com 07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
4.3 Electrical connection
The flow sensor is connected to the signal converter via the single signal cable.
4.3.1 Signal cable to flow sensor
CAUTION!
To ensure smooth functioning, always use the signal cables included in the delivery.
Figure 4-3: Connecting the signal cable to the rail (small and medium version)
1 Connect the green cable to "DOWN"
2 Connect the blue cable to "UP"
3 Turn the screws clockwise to secure the cap
Figure 4-4: Connect the signal cable in case of stainless steel / XT version.
1 Put in the connector.
2 Turn knob to secure the connector.
CAUTION!
For XT versions: check if the signal cable is heat protected with the protection sleeve of 1 meter /
40".
.book Page 31 Tuesday, August 18, 2009 4:51 PM