Modbus protocol description and set-up, 7 default settings – KROHNE ALTOSONIC V12 EN User Manual
Page 126
10
MODBUS PROTOCOL DESCRIPTION AND SET-UP
126
ALTOSONIC V12
www.krohne.com
04/2013 - 4002643502 - MA ALTOSONIC V12 R02 en
10.7 Default settings
By means of a number of parameters the Modbus communication link can be adjusted to one’s
needs or preferences. When the ALTOSONIC V12 meter is delivered these parameters are set to
default values as listed below:
Port 0
Port 1
Baud rate:
38400
Data bits:
8
Stop bits:
1
Parity:
Even
Modbus Mode:
RTU
Modbus End Code:
2
Addressing Mode:
Modicon compatible
Representation
Mode:
Normal
Modbus Address:
237
Modbus Start Gap:
40 (bits)
Modbus End Gap:
20 (bits)
Modbus Start
Code:
":" (colon character)
Modbus End
Code1:
ASCII 13 (carriage return, CR)
Modbus End
Code2:
ASCII 10 (line feed, LF)
Modbus Time Out:
1 second
Baud rate:
115200
Data bits:
8
Stop bits:
1
Parity:
Even
Modbus Mode:
RTU
Modbus End Code:
2
Addressing Mode:
Modicon compatible
Representation
Mode:
Normal
Modbus Address:
237
Modbus Start Gap:
40 (bits)
Modbus End Gap:
20 (bits)
Modbus Start
Code:
":" (colon character)
Modbus End
Code1:
ASCII 13 (carriage return, CR)
Modbus End
Code2:
ASCII 10 (line feed, LF)
Modbus Time Out:
1 second