KROHNE ALTOSONIC V12 EN - Manual (Page 77)

SERVICE
8
77
ALTOSONIC V12
www.krohne.com 04/2013 - 4002643502 - MA ALTOSONIC V12 R02 en
Steps to install a transducer:
Figure 8-8: Pulling out the transducer
1 Pull to remove the transducer
2 Turn the transducer to loosen the transducer from the tool
CAUTION!
• Make sure that the inside of the transducer nozzle is completely clean.
• Make sure that the two O-rings of the new transducer are a little greasy.
Figure 8-9: Installing transducer in tool
1 Put the tool on the transducer.
2 Turn the tool clockwise to attach it to the transducer.
Figure 8-10: Replacing the transducer
1 Firmly push the wrench. Two o-rings snap in place.
2 Loosen the wrench by turning it counter clockwise.
CAUTION!
Make sure that the transducer does not come loose when you rmove the wrench.
INFORMATION!
Put a little grease on the screw thread of the transducer nut to make it easier to install.