KYORITSU 6305 Instruction Manual - Manual (Page 91)

KEW6305
7.8
● Indications on each wiring configuration
The following messages are displayed on the screen according to each wiring configuration.
Displayed contents
Wiring（ “ Setting 01”） Displayed at
Screen1 Screen2 Screen3 Screen4
Upper TIME
Middle WP 1P2W (1ch)
Lower WS
- - -
Upper TIME TIME TIME
Middle WP WP1 WP2
1P2W (2ch)
1P3W
3P3W
Lower WS WS1 WS2
-
Upper TIME TIME TIME TIME
Middle WP WP1 WP2 WP3
1P2W (3ch)
3P3W3A
3P4W
Lower WS WS1 WS2 WS3
Legend:
TIME : Elapsed time of integration
WP : Total active electrical energy
WP1/WP2/WP3 : Active electrical energy per phase
WS
: Total apparent electrical energy
WS1/WS2/WS3 : Apparent electrical energy per phase
7.5 Saving data
When integration or demand measurement starts, the measured data will be saved automatically.
There are two locations where data can be saved.
* SD card : Max. 511 files can be saved.
* Internal memory : Max. 4 files can be saved.
Data is saved to a SD card automatically when a SD card has been inserted before turning on the
instrument. If the SD card has not been inserted, data is saved automatically to internal memory.
7.5.1 Saving Procedure
* When a survey is started (manually or automatically) a file is opened.
* Data is saved at the end of each integration interval (“
Setting 09”).
Elapsed time
Recording interval
1 2 3 n-1 n
Start of survey Data saving point End of survey
* When the survey is closed (manually or automatically) the file is closed
* All the recorded parameters at each data saving point are saved to one file.