NOSHOK 5301 Series Load Pins - Manual (Page 2)

Operating manual
5301 Series Load Pins
2
Safety note
Use for intended purpose
The force transducers in model series F5301 are intended for the
measurement of static and dynamic tensile or compressive force.
These devices have been constructed and tested in accordance with
the safety regulations for electronic measuring equipment.
Any other usage is deemed to be incorrect . The transducers can only
be guaranteed to operate correctly and safely if the information in the
operating instructions is complied with. The legal and safety
regulations that apply to the respective application must also be
observed during use (e.g. VDE 0100). This also applies to the use of
accessories.
The transducer is not intended to be used a safety element.
The correct and safe operation of this transducer depends on correct
transportation and proper storage, installation and assembly and
careful operation and maintenance.
General dangers if the safety instructions are not followed
Force transducers made by tecsis are manufactured in accordance
with the latest state of technology and are safe during operation.
However, the transducers can be the source of residual danger if they
are used or operated improperly.
Any person who is entrusted to install, start up, maintain or repair a
force transducer must have read and understood the operating
instructions, particularly the technical safety instructions.
Residual dangers
The performance and scope of delivery of the transducer only cover a
sub-area of force measuring technology. The technical safety aspects
of force measuring technology must also be planned and implemented
by the system planner / equipper / operator in such a way that residual
dangers are minimised. The existing regulations must be complied
with. Residual dangers associated with force measuring technology
must be pointed out.
NOSHOK, Inc. • 1010 West Bagley Road, Berea, OH 44017 • Ph: 440.243.0888 • Fax 440.243.3472 • www.noshok.com