Revo R4-8-16DVR3 - Manual (Page 23)

4, 8 &16 Channel Digital Video Recorder
17
NETWORK SETUP
General Settings (NETWORK
 General Tab)
 Transfer Speed: Set the transfer speed, and select the
unit of measure for the transfer speed between bps (bits
per second) and ips (images per second).
 Quality: Select the quality of the transferred image.
 Resolution: Select the resolution of the transferred image.
(16-ch model only)
NOTE: The local recording speed might be affected by
various network bandwidth (Transfer Speed) conditions.
NOTE: The higher Quality and Resolution settings require
higher Transfer Speed settings. The transfer speed you
set is the maximum speed. Depending on the network
environment, this speed may not be achieved.
 Remote Audio Channel: The DVR supports remote audio communication between a PC running REVO Remote Pro
or REVO Remote and a local system. Select the audio channel that sends audio to the remote site. Selecting Select
From REVO Remote
will send audio of the channel selected from REVO Remote Pro or REVO Remote.
NOTE: Depending on network conditions, audio might be interrupted or out of synchronization during
transmission.
 Network Bandwidth Limit: You can limit the network bandwidth settings so that system does not consume too much
network bandwidth. Set the desired maximum bandwidth from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running REVO Remote Pro
or REVO Remote might not be displayed properly.
 Enable SSL for Transferring Data: Selecting the box turns the SSL (Secure Sockets Layer) authentication On.
When it is On, the security of data, except video transmitted for remote monitoring or remote recording can be enhanced
by using the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected
with a remote program or a network keyboard which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the SSL
settings.
NOTE: This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/).
 Use REVO Remote Service: Selecting the box turns the REVO Remote service On. Select the port number used
when accessing REVO Remote. See Appendix – REVO Remote for details.
 Mac Address: Displays the MAC (Media Access Control) address of the DVR.