Revo R4-8-16DVR3 - Manual (Page 45)

4, 8 &16 Channel Digital Video Recorder
39
 To: Pressing the
button to toggles between On and Off. When set to Off, you can enter a specific Date and Time.
When set to On, the search will be to the last recorded image. When highlighting and pressing the button the
bookmark list displays and the bookmark point you selected will be the ending date and time (16-ch model only).
 Type: Motion Search detects motion in the defined area.
 Zone: Press the button, and an image from the video appears with a grid overlay. You can turn sensor blocks
On and Off to define the area of the picture in which you want to search for motion. The zone should be placed or
focused on the centre or, at least, within the outline of targeted object.
NOTE: Defining the area of the image in which you want to search for motion is nearly identical to setting up
the DVR for Motion Detection. Please refer to the Motion Event Settings section in Chapter 2 — Installation &
Configuration – Advanced Setup, Event Setup for more detailed instructions on setting up the detection blocks.
 Sensitivity: Select the sensitivity from 1 (low sensitivity) to 5 (high sensitivity).
 Min. Blocks: Set the number of sensor blocks that must be activated.
Once you set your desired search conditions, select Search and press the button to display the search results in the
Motion
Search screen. Selecting Cancel exits the screen without saving the changes.
When you search for motion events for another camera, you will be asked whether or not you want to delete the previous
search results from the list.
GO TO
Go to the First
Selecting Go to the First displays the first recorded image.
Go to the Last
Selecting Go to the Last displays the last recorded image.
Go to the Date/Time
You can use the Left and Right arrow buttons on the remote control to select the year,
month, day, hours, minutes and seconds. Use the Up and Down arrow buttons to change
to the date and time you want to search for video. Once you have set the date and time,
press the
button. Then select Go and press the button to display the image recorded
at the selected time. The Playback buttons on the remote control can now be used to review
the surrounding video. (If no video was recorded during the selected time, a message
appears alerting you that no image was recorded at that time.)
BOOKMARKS
The Bookmarks screen can be accessed by selecting (Bookmark) in the Search menu when in playback mode. (16-ch
model only)