Revo R4-8-16DVR3 - Manual (Page 30)

User’s Manual
24
Select/Select All – Activates highlighted blocks or all blocks
to detect motion.
Clear/Clear All – Deactivates highlighted blocks so that
they will not detect motion.
Reverse/Reverse All – Activates inactive highlighted blocks
or all inactive blocks and deactivates active highlighted
blocks or all active blocks.
OK – Accepts changes and closes Zone setup.
Cancel – Exits Zone setup without saving changes.
NOTE: You can select the block groups to be selected or cleared by using the mouse. Place the mouse pointer
where you want to start the line. Hold down the left mouse button and drag the pointer to where you want to
end of the line. Release the mouse button and a group of blocks appears along the line you drew. You can
draw lines around shapes by repeating this process.
 Min. Blocks: Set the minimum number of detection blocks that must be activated to
trigger a motion alarm for Daytime and Nighttime independently.
 Actions: Set the actions the DVR will take whenever motion is detected on the
selected camera. Motion event can sound the external alarm or DVR’s internal
buzzer, notify a number of different devices, and/or move PTZ cameras to preset
positions.
Alarm Out – Select the alarm-out signals (Alarm-Out and Beep) to be associated with
the camera.
Notify – Select Mail if you want to send an e-mail to the address set during NETWORK – Mail setup.
PTZ – Select the preset position for each PTZ camera, where you want PTZ cameras to move to.
NOTE: For the Notify action to work, the Mail should be enabled in the NETWORK – Mail setup.
 Motion Ignoring Interval: Set the motion ignoring dwell time. You can control excessive event logging and remote
notification of motion detected after the motion dwell time by adjusting the motion ignoring dwell intervals. The
DVR will not log and notify motion events occurred during the preset interval range. The recording for motion events
will not be affected by the Motion Ignoring function.
 Daytime Setup…: Select the button and set the Daytime range. The DVR will
consider the remaining time range as the nighttime.
Alarm-In Event Settings (EVENT
 Alarm-In Tab)
 No.: Selecting the box toggles each alarm input On and Off.
 Type: Set each alarm input as NO (Normally open) or NC
(Normally closed).