Revo RESPTZ37-1/HSC/HSW Advanced Features - Manual (Page 11)

REVO America www.revoamerica.com RESPTZ37-SERIES
9
DWELL:
Sets the time that the camera stays on the start and end points before
scanning. 01-99 seconds.
To create an Auto Scan, proceed as follows:
1. Press the SCAN key on the keyboard controller to enter the Auto Scan menu directly. Or
press the MENU key to display the main menu on the monitor. Scroll to Auto Scan and
move the joystick to the right.
2. Select NUMBER and set the desired number by moving the joystick to the left or right.
3. Select TITLE and twist the joystick to enter the title edit mode. Refer to the Titling
procedure.
4. Select MODE and SPEED. Note that Vector settings will enable you to set both horizontal
and vertical angles, so you can start at the ceiling at the right side of the scene and end at
the floor on the left side. Use a medium range speed at first, then experiment. Speeds that
are too slow or too fast may not produce the results that you want.
5. Select START ANGLE. Hold down the CTRL key while selecting the horizontal start
position using the joystick. The current position will be displayed. Release the CTRL key to
complete the selection. Move to the vertical position and repeat the procedure. Select the
zoom position by rotating the joystick right or left.
6. Select END ANGLE. Hold down the CTRL key while moving the joystick to select the
horizontal end position. The end position angle should be larger than start position.
Release the CTRL key to complete the selection. Move to the vertical position and repeat
the procedure. Select the zoom position by rotating the joystick right or left.
7. Set SCAN DIR either CCW or CW.
8. Select SWAP and set to ON to exchange the start angle and the end angle. Otherwise, skip
over it.
9. Set DWELL TIME from 01-99 seconds.
10. Select SAVE AND EXIT and move the joystick to the right. Press the ESC to exit the
program without saving.
CAUTION
Pressing the HOME key will delete stored data at the angle field.
11. To store the Auto Scan that you created as the default programmed action for the camera,
navigate to the DOME SETUP menu and select HOME FUNCTION. Refer to the Home
Function
procedure.