Revo RESPTZ37-1/HSC/HSW Advanced Features - Manual (Page 20)

REVO America www.revoamerica.com RESPTZ37-SERIES
18
2. By pressing the PRST key, the camera will move to the stored Preset view and the cursor
will move to the DWELL time field.
3. After changing the Dwell time, press the PRST key and the cursor will move to the Preset
number.
To assign functions other than Preset in the Tour when the function key is not available:
1. Use the joystick to move the cursor to a stored Preset position.
2. Press the CTRL key to change the Preset number to another function such as: Auto Scan,
Pattern, Tour, Preset).
3. To change the function number, twist the joystick right or left.
Alarm
The Alarm Setup menu enables you to set alarm inputs and outputs to and from the camera.
ALARM SETUP
NO PRI FUN IN OUT HLD LATCH
01 1 001 NC OFF 03 OFF
02 2 A01 NO OUT1 03 OFF
03 1 --- OFF OUT1 03 OFF
04 1 --- OFF OUT4 03 OFF
05 1 --- OFF OFF 03 OFF
06 1 --- OFF OUT1 03 OFF
07 1 --- OFF OUT1 03 OFF
08 1 --- OFF OUT4 03 OFF
DWELL : 03
RELAY OUT SETUP
SAVE AND EXIT(ESC TO CANCEL)
NO:
There are 8 input Alarms available.
PRI:
Each Alarm may be assigned a priority. There are 9 levels of priority,
with “0” having the highest priority. Lower priority alarms won’t be
serviced until the higher priority alarm is completed. Equal priority
alarms will be serviced repeatedly within the Dwell time.
FUN:
Function. Stored function number to be called by alarm. This can be a
Preset, Auto Scan, Pattern or a Tour.