Revo REVDN700-2 - Manual (Page 12)

If you exit menu, doing Initialize started while 4~5 seconds the background.
During initialization the background, it is good to be none of moving objects.
When Day / Night mode is changed or Cam Set is changed, the background of the re-
initialization performed.
Global Functions
: This functions being performed in the entire area.
- Output Select : It must be specify the outputs, each function will be enabled.
Press [Enter Key], to select output of each detection zone.
Alarm: Trigger alarm to output port.
Communication: Event string sends on RS-485
Screen: Display on screen.
Back: return to previous menu.
- Detections
Motion: General motion detection
Loitering
: Within a set period of time, detect loitering objects of entire screen.
NOTE:
* Please don’t use as a signal for video recording start.
* The result of loitering detection can be inaccuracy.
Abandon/Absent: Detect the difference to stored background.
NOTE:
* Please don’t use as a signal for video recording start.
* The result of abandon/absent detection can be inaccuracy.
Scene Change
: Detect a change in the screen.
NOTE:
* It is good for detecting scene change, including vertical lines or high contrast objects of the
background.
* Please don’t use as a signal for video recording start.
* The result of scene change detection can be inaccuracy.
Windy Area Detection
: Detect continuous movement caused by wind or etc.
If same movement occurs in same area, alarm is ignored in this area.
If no motion is detected for a period of time, windy area turns off.
NOTE:
* Please don’t use as a signal for video recording start.
* In Simple mode is not supported.
* The result of windy area detection can be inaccuracy.
1) Zone Base Functions
Max 10 Zone can be configured.
NOTE:
* Because they share area ID with Privacy mask, it can not be used same ID.
- Zone: Select zone ID.
- Func(Function) : Zone Function On/Off (Blinking enabled area).
- Shape: Select area shape.
Color
: Select area’s frame color.
Rect(Rectangle) : Adjust rectangle with 4-arrow keys.
Press [ENTER] key is to finish edit area.
12