SHIMPO DRI-series - Manual (Page 11)

11
External Control Commands
The chart below lists the ASCII Capital Characters and their
functions for controlling the DRI from a computer or other
external device:
COMMAND FUNCTION DATA
UNTG Change units to g or kg
UNTN Change units to N
UNTL Change units to lb or oz
DSPN Change mode to average
DSPT Change mode to peak tension
DSPC Change mode to peak compression
PKCL Peak clear reset
MEMS Display value stored in memory
MEMC Last data in memory clear
MEMD Memory data output
MEMZ Clear all data in memory
MEMN Memory location recall
CPST Upper and lower limit set
Z Tare
UPD Display update 1,2,3,4,5
APF Auto – power – off 0,3
EXS External input setting Z,H,N
HLD Hold trigger mode E,L,O,C
LOG Memory mode setting S,C,N
PKF Peak fast mode 0,1
DAF Analog output setting 0,1
ADF Filter setting 0,1,2
D Output display data
DATN Output average mode data
DATT Output tension peak data
DATC Output compression peak data
LIST Gauge’s present state
AB Stop continuous data output
BB Continuous data output request
BC Model name confirmation request
BD Units confirmation request
Communication With External Devices (continued)
External Control Command Descriptions
ASCII capital characters
! UNTG, UNTN, UNTL - Change UNITS to Kg, N, lb
UNTG CR... Kg(g)
UNTN CR... N
UNTL CR... lb (oz)
! DSPN, DSPT, DSPC - Change to average, peak tension,
peak compression mode
DSPN CR... Change to average mode
DSPT CR... Change to peak tension mode
DSPC CR... Change to peak compression
! PKCL _____________________ Peak Clear
PKCL CR.... Peak reset. Same as reset from the gauge. If edge
trigger is selected for HOLD, the PC can release the HOLD using
this particular command.
! MEMS, MEMC, MEMD, MEMZ, MEMN
(five control memory commands)
MEMS CR.... with this command if gauge is set in the ON-
DEMAND (single) mode, it sends back to the computer the
word SING. If gauge is set in the continuous or standard
mode then when this command is sent and the gauge’s
memory starts, it sends back to PC the word STA. If memory
stops, the word STP is sent back to the PC.
MEMC CR.... Last DATA in memory to clear
MEMD CR ....Memory DATA recall
MEMZ CR ... Clear all DATA in memory
MEMN CR ....Memory location recall
! CPST _________________________Comparator Setting
CPST 0 0000 0 0000 CR
Example: CPST "1234-0123 CR
! Z _________________________________ TARE
Z CR .... To TARE. Works the same way as if it were done thru
the gauge i.e SHIFT + ZERO.
! UPD ________________________ Display Update Time
UPD # CR "# = 1: 0.125 sec.
2: 0.25 sec.
3: 0.5 sec.
4: 1 sec.
5: 2 sec.
UPPER
LIMIT
LOWER
LIMIT
SIGN SIGN
need 4-digit # (fill with zeros) SPACE