SHIMPO DRI-series - Manual (Page 19)

19
The following are general checkpoints; please call your local Shimpo representative or contact Shimpo Instruments directly for further assistance.
The DRI does not turn on:
• Check all electrical components (power source … battery or power cord)
The DRI does not recognize a sensor:
• Check connection between the DRI and the remote sensor
• Refer to calibration instructions for a sensor that cannot be recognized
Error Codes are displayed:
• If any error codes appear on the display, turn power OFF and then ON
• If error code remains, see table below:
Troubleshooting
Calibration (continued)
DISPLAY CONDITION ACTION
EE PROM reading error Press RESET; unit will default to
factory settings
Memory data error Press RESET to clear memory
Calibration error Press RESET and repeat calibration
procedure
Memory unit error; occurs if the Change measurement units or clear
measurement unit (lb, Kg, N) is memory
changed while entering data into
memory
Sensor error; occurs if the remote Change sensor or clear memory
remote sensor is changed during
data entry to memory
Overload condition –possible
Remove excessive load; if the display
load cell damage does not return to normal operation,
send unit in for repair
MODEL SELECT NUMBER DISPLAY CALIBRATION WEIGHT
LC-50S 06 50L 25kg
LC-100S 07 100L 50kg
LC-200S 08 200L 100kg
LC-500S 10 500L 250kg
TS-3SD, TS-3J 18 t50o
TS-10SD, TS-10J 19 t10L
TS-20SD, TS-20J 20 t20L
TS-50SD, TS-50J 21 t50L
TS-100SD, TS-100J 22 t100L
Please call Shimpo for information on additional sensors.