Techne Prime Elite - Manual (Page 46)

44
SETTINGS
• Touch the Settings button to view the
instrument defaults as set up in the Settings
module.
Any of these parameters can be edited by touching
the appropriate button and will be saved for the
current program only.
• Touch Program to return to the programming
screen.
VIEW
• Touch View to see a graphical representation of
the program.
• If the program has more stages and steps that
are displayed on the screen, scroll through the
program by dragging a finger across the touch
screen.
The centre of the screen shows each temperature
step and hold time (not to scale). Stages are
indicated by a white bar spanning the steps within
the stage.
The bottom of the screen shows the name of the
program and the expected end time if it was started
immediately.
Note: The program is not saved at this point.
• Touch Start to start the program.
Note: It is not possible to send the program to connected Satellite units from a view screen.
• Touch Edit to edit the program.
• Touch Back to return to the Programming Screen.
Note: The temperature log will remain blank until the program has been started.
If a step has a gradient programmed into it, the bar
will be shown thicker and indicate the upper and
lower temperatures of the gradient range.
If a step has an incremented or decremented
temperature, this will be indicated by a white spot
next to the temperature.
If a step has an incremented or decremented time,
this will be indicated by a white spot next to the
time.
Gradient Inc/dec
temperature
Inc/dec time Gradient Inc/dec
temperature
Inc/dec time