Thermo Fisher Scientific CyberComm 6000 for CyberScan Series 6000 - Manual (Page 23)

Instruction Manual CyberComm 6000
17
(a) (b)
Figure 17 : COM Port Configuration
ƒ If CyberComm is already connected to the selected COM port, the ‘COM Port
Status’ field shows ‘COM Port is OK’ and the two drop-down boxes are read-
only. [Figure 17 (a)]. To change COM port configuration, click Disconnect
button.
ƒ If the CyberComm is not connected to the selected COM port, the ‘COM Port
Status’ field shows ‘COM Port Failed’. [Figure 17 (b)]
2. Select the correct COM port from the COM Port drop-down box.
3. Click Connect button to connect to the selected COM port.
Note: If you are using a USB-to-Serial conversion cable to connect the
meter to USB port of the PC, you may need to check the Device
Manager of your PC to see what the exact port number is.
Right-click on My Computer icon. Click on Properties pop-up menu to
open System Properties. Click Hardware tab and then click Device
Manager. See the applicable COM port name under ‘Ports (COM & LPT)
as shown in Figure 18.