Thermo Fisher Scientific CyberComm 6000 for CyberScan Series 6000 - Manual (Page 58)

Instruction Manual CyberComm 6000
52
5. The right-pane displays standardization data available for the selected
parameter/buffer group. You can unselect any of the standardization data by
clicking on the check box against the data to de-select it.
6. Click OK to add the selected data to the report. The selected standardization
data is added as a block of data. (Figure 43) You may format the look and feel of
this block, if required.
Figure 43 : Standardization data added as a block
7. You may add standardization data of another channel/parameter to the same
report. Click on Select button and make your selection again and click OK. The
newly added set of data is added to report as a separate block.
8. Optionally, you may select a block of data and press Delete keyboard button to
delete a block, if you wish to remove them.