Document Outline

• 68X216877-4-manual_for_pH 560.pdf
  • 68X216877-4-manual_for_pH 560.pdf
    • Introduction
      • Before You Begin
      • Intended Use
      • Safety Instructions
      • Taking Out of Service
      • Correct Disposal of the Unit
    • Getting Started
      • Description of Instrument
      • Measurement and Control System
      • Connection Terminals
        • Connectors:
        • Switching Between PT100 & PT1000 Temperature Sensors
          • Remove Back Cover
          • Remove Back PCBA
          • Set Jumper J7
      • Connecting pH/ORP Electrode
      • Connection Terminals
        • Connecting Temperature Probe
        • Connect Potential Matching Pin (PMP)
      • Installation
        • Mechanical Dimensions
        • Wall Mount
        • Panel Mount
      • Display & Keypad
        • Display Overview
        • Mode Indicators
        • Status Annunciators
        • Units of Measurement Indicators
      • Key Functions
    • Operation
      • Measurement Mode
      • Menu Overview
    • Calibration Mode
      • Preparing the Controller & Electrode for Calibration
      • Entering pH/ORP Calibration Mode
      • pH Calibration
        • For USA Standard Buffer
          • 1-Point Calibration:
          • 2-Point Calibration:
        • For NIST Buffer
          • 1-Point Calibration:
          • 2-Point Calibration:
      • ORP Calibration
      • Temperature Calibration
      • Enter Setup Mode
    • Setup Mode
      • Electrode Offset Settings
      • Temperature Settings
      • Relay A/Relay B Setting
      • Controller Settings
      • Buffer Selection Settings
        • Configuration Settings
      • Viewing Electrode Properties
    • Technical Specifications
    • List of Accessories
    • Troubleshooting
    • General Information
    • Appendices
      • pH Buffer Values at Various Temperatures
      • Graphical Representation of the Function of Hysteresis
      • General Instructions Concerning Controller Settings
      • Abbreviations Used in LCD
    • Asymmetrical mode
    • Automatic Temperature Compensation
    • Buffer
    • Calibration
    • Calibration temperature
    • Electrode properties
    • Configuration
    • Controller
    • Default values
    • De-energized
    • Energized
    • Factory (defaults)
    • High limit
    • Hysteresis
    • Backlight
    • Low limit
    • Offset
    • Off delay
    • On delay
    • Reading is over range
    • Oxidation Reduction Potential
    • Process temperature
    • pH
    • Setting
    • 1st Set point
    • 2nd Set point
    • Symmetrical mode
    • Type
    • Reading is under range