Thermo Fisher Scientific Alpha pH 100 User Manual
Page 3
2
TABLE OF CONTENTS
1.
Introduction------------------------------------------------------------ 3
2.
Getting Acquainted-------------------------------------------------- 4
2.1
Front Panel............................................................. 4
2.2
Back Panel ............................................................. 5
2.3
Selecting pH/ORP Measurement Mode .................. 6
2.4
Wiring ..................................................................... 6
3.
Operating the Controller ------------------------------------------- 7
3.1
The Main Display.................................................... 7
4.
Setting Up the Controller ------------------------------------------ 8
4.1
Setting and Changing the Password....................... 8
4.1.1
Setting New Password......................................................... 8
4.1.2
Changing the Password....................................................... 9
5.
Calibrating the Controller ---------------------------------------- 10
5.1
The Lower Level Menus........................................ 10
5.2
Calibrating for pH Measurement ........................... 10
5.2.1
The CAL PH menu............................................................. 10
5.3
Changing the Offset.............................................. 11
5.4
Calibrating for ORP Measurement ........................ 12
5.5
Calibrating for Temperature Measurement ........... 12
5.5.1
The CAL
°
C Menu.............................................................. 12
5.5.2
ATC ON/OFF ..................................................................... 13
5.6 Setting the Alarm Feature ................................... 15
5.6.1
The Hi SET Menu .............................................................. 15
5.6.2
The Hi HYS Menu .............................................................. 16
5.6.3
The Lo SEt Menu ............................................................... 17
5.6.4
The Lo HYS Menu ............................................................. 18
6.
Using the Controller Current Loop for Datalogging (for
Transmitter Model Only)------------------------------------------------- 19
7.
Additional Information -------------------------------------------- 20
8.
Appendix 1 - Jumper Positions (Inside Controller) ------- 21
9.
Appendix 2A - Jumper Positions (pH) ----------------------- 23
10.
Appendix 2B - Jumper Positions, ORP --------------------- 24
11.
Appendix 3 - pH Offset / Slope -------------------------------- 25
12.
Technical Specifications ---------------------------------------- 26