Badger Meter Series 735 Sensors - Manual (Page 10)

SPECIFICATIONS
Wetted Materials (except tees) See "Ordering Matrix" in Technical Brief for material specifications.
Materials
Tee PVC Type 1, white
Adapter PVC Type 1, gray
BSP Fitting PVC Type 1
Sensor Housing PPS
Retaining Nut Acetal copolymer, black
Locating Pin 300SST
Impeller 300SST
Shaft Tungsten Carbide
Bearing UHMWPE
O-Rings EPDM
Wires 18 AWG Irrigation Wire (solid copper)
Pressure/Temperature
Ratings
(DO NOT EXCEED)
150 psig @ 73° F
75 psig @ 110° F
Rated Temperature
(DO NOT EXCEED)
Operating: 35…110° F
Storage 14…110° F
Recommended Design Flow
Range
2…20 ft/sec
Accuracy ± 3.0% of full scale over recommended design flow range
Repeatability ± 1.5% of full scale over recommended design flow range
Linearity ± 1.5% of full scale over recommended design flow range
Transducer Excitation • 8…35V DC max. input, source limited to 100 mA
• Quiescent current 600 uA @ 8…35V DC max.
• Quiescent voltage (Vhigh=Supply Voltage–(600 uA*Supply impedance))
• ON State (Vlow) Max. 1.2V DC @ 40 mA current limit (15 Ω + 0.7V DC)
Output Frequency 3.2…200 Hz
Output Pulse Width 5 msec ±25%
Environmental • IP 68 / NEMA 4X
• Suitable for pollution degree 4 environments
• Suitable for outdoor use above or below grade
• Suitable for use in 100% humidity
Electrical Cable for IR Sensor
Electronics
UL Style 116666 copper solid AWG 18 wire w/direct burial insulation. Rated to 105° C.
Series 735PV Plastic Tee Type Impeller Flow Sensor
Page 10 January 2013