How to set the flow rate unit, Bulletin f-107-uxf3 – Dwyer UXF3 User Manual
Page 42
-34-
4.8.2. How to set the flow rate unit
Description
z Select the unit of flow rate.
z Metric system
Flow rate ········· L/s, L/min, L/h, L/d, kL/d, ML/d, m
3
/s, m
3
/min, m
3
/h (factory set), m
3
/d, km
3
/d, Mm
3
/d, BBL/s, BBL/min, BBL/h, BBL/d,
kBBL/d, MBBL/d, gal/s, gal/min, gal/h, gal/d, kgal/d, Mgal/d, ft /s, ft /min, ft /d, kft /d, Mft /d, barrels (BBL units)
<Note> First, set the unit system (metric) according to Section 4.8.1.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand. (See Section 4.4.1.)
Operation
(example)
Set a flow rate unit to “L/min”.
Key operation
Description
Display
ź
Press the
key 3 times to display “MEASURE SETUP”.
MEASURE SETUP
ENT
ź
Press the
ENT
key once to display “SYSTEM UNIT”.
SYSTEM UNIT
METRIC
ź
Press the
key once to display “FLOW UNIT”.
FLOW UNIT
m3/h
ENT
ź
Press the
ENT
key once to blink the cursor.
FLOW UNIT
m3/h
ź
Press the
key several times to display “L/min”.
FLOW UNIT
L/min
Press the
ENT
key once to register.
FLOW UNIT
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ “L/min” has been registered. ʊʊʊ
FLOW UNIT
L/min
ESC
Press the
ESC
key once and the
key twice to return to the
measurement mode.
0.000 m/s
0.000 L/min
Bulletin F-107-UXF3
3
3
3
3
3