JJC TM Series Multi-Function Timer Remote control - Manual (Page 5)

To ensure correct operation, choose an interval at least two seconds longer than the exposure time.
When using autofocus, set the delay to two seconds or more and choose an interval at least two seconds
longer than the exposure time to ensure that the camera has time to focus. When using long exposure
noise reduction, the interval should be at least twice the exposure time.
Intervals of 00:00:00 will automatically be reset to 00:00:01 when the SET button is pressed to put
settings into effect.
To set the number of shots to - - (unlimited), select 1 and press the arrow button down or select 399
and press the arrow button up.
After adjusting all setting, press the SET button to put the new settings ENABLE. A beep will sound (If the
speaker is ON) and the “SET” icon indicator will go out.
Start Start Start Start the the the the timer timer timer timer
Press the START/STOP button. The timer will start and “TIMER ACTIVE” will flash in the control panel.
Between shots, the control panel will show the time remaining until the next photograph is taken. If the
speaker is ON, a keep will sound three times at ONE-SECOND intervals before the shutter opens.
While the shutter is opened, the control panel will show the time remaining until the shutter closes, and
the release lamp and “RELEASE” indicator will flash at ONE-SECOND intervals. The number of shots
remaining will be updated each time a photograph is taken.
5.Speaker
1. Flashes while timer is active
2. Between Between Between Between shots shots shots shots: Time remaining until next
shot. While While While While shutter shutter shutter shutter is is is is open open open open: Time remaining
until shutter closes.
3. Number of shots remaining
4. Flashes while shutter is open