NORD Drivesystems TI043_278910340 - Manual (Page 2)

Getriebebau NORD GmbH & Co. KG
Rudolf-Diesel-Straße 1 · D-22941 Bargteheide
Tel.: +49 45 32 - 40 10 · Fax: +49 45 32 - 40 12 53 · www.nord.com
Connection kit
WK 4/2/4*680 Ohm
TI 043 278910340 2/2
1.0 First edition 06.07.10 Rck
Version Change Datum Name Document Page
Connections:
The electrical connection of the encoder and the frequency inverter is via screw terminals according to the table (see illustration
above).
Function Wire colour: HTL
encoder Terminal number
Connection kit WK 4/2/4*680 Ohm Terminal number,
frequency inverter
Supply voltage 10 - 30V DC brown / green 1 42 (VO 15VDC) or 44 (VO 24VDC)
0V / GND white / green 2 40 (GND)
Track A brown 3 51 (ENC A+)
Track A / green 4 52 (ENC A-)
Track B grey 5 53 (ENC B+)
Track B / pink 6 54 (ENC B-)
Tools:
Slot-head screwdriver 0.6 x 3.5
Installation data:
Dimensions: [mm] H63 x W38.5 x D48
Mounting: Snap-on rail mounting (35mm snap-on DIN rail / TS35)
Commissioning information:
The connection kit is delivered as individual parts and must be
correctly mounted on a snap-on DIN rail on site. The following
mounting sequence (starting on the left) must be observed:
1. 2 x through terminal (WK4/U/VO)
2. 4 x fuse terminal (WK 4TKG/U/VO),
3. 1 x Cover plate (AP 4 TK/VO).
The 4 x enclosed diode plugs must be mounted on the insulated
base terminals (snap-on). The enclosed labelling strips must
also be attached.
The connection between the frequency inverter and the
connection kit should be as short as possible. The use of a shielded connection cable is recommended. The shield must be
well earthed at both ends. The shield of the encoder cable must also be connected to PE.
Scope of supply:
Item Name Name Number
1 Labelling strip (1 ... 6) 9705A/6/10B 1-10 horizontal 1
2 Diode plug 680 Ohm +/- 11% /0.6W 4
3 Through terminal WK 4/U/VO 2
4 Fuse terminal WK 4 TKG/U/VO 4
5 Cover plate AP 4 TK / VO 1