Setra System Model Datum 2000 - Manual (Page 8)

8
USER SETUPS
The menu tree below represents the meter program structure. To enter the
menu and select a channel, press and hold the SCAN/adj and HOLD/mode
keys for 8 seconds, then release; the display will alternate between “cal” and
“noYes” for ten seconds.* To specify “yes” and select “CH1”, press and hold
the HOLD/mode key until “CH1” displays. To specify “no”, press and hold
the SCAN/adj key. The display will return to normal operation. (To select
“CH2”: With “CH1” displayed, press and release the SCAN/adj key to
display “CH2”.) When choosing menu options, you have 30 seconds to
press a key before the meter defaults to normal operating mode.
To view the commands listed for the displayed channel, press and release
the HOLD/mode key to display “ALAr” . Then press and release the SCAN/
adj key (repeat) to display each command until the display returns to normal
operation.
*NOTE: If the meter has not been calibrated at the factory, when the meter is turned
on, the display will alternate between “cal” and “noYes” .
CH1
Return to normal operation.
CH2
cal
Cal is lit when
in calibration
mode.
0.000
Display
SCAN
adj
HOLD
mode
Return to normal operation.
CAL_U Calibrate CH2 for voltage in (transducer).
CAL_C Calibrate CH2 for current in (transmitter).
OFF57 Set an offset value.
ALAr Set the alarm points.
Return to normal operation.
OFF57 Set an offset value.
ALAr Set the alarm points.
CAL_U Calibrate CH1 for voltage in (transducer).
CAL_C Calibrate CH1 for current in (transmitter).