Sterlco SSC Conveying Systems - Manual (Page 22)

Page 21 of 38
5 Using the Controller
5-1 Introduction
This chapter gives the procedures for configuring your
SSC1-5Q controller.
Configuration of your SSC1-50Q controller includes setting
the number of stations, setting variables such as convey
time and blow-back interval. Sterling recommends that you
carry out these procedures in the order given here.
5-2 Setup
Important! Before carrying out these procedures, install all equipment as
described in Chapter 4: “Installation”, and in the manual SPD/SPC
Series Conveying Systems.
5-2-1 Setting Up the System
This section provides an overview of the controller screens used in
configuring the system. Section 6 provides a detailed explanation of the
features listed on each screen.
5-2-1-1 Basic Menus and Setup of Controller
Once power has been applied to a properly installed
system, turn the disconnect switch to the ON position.
The alpha controller will display the screen for receiver 1
(Hopper 1).