Sterlco Upright High Temperature Heat Transfer - Manual (Page 25)

Upright Portable Hot Oil TCUs Chapter 4: Operation 25
Identifying Control Panel Switches
This section lists the descriptions and functions of the control panel switches. These switches
control the operation of the unit.
Figure 4: Control Panel Switches
Pump Start. Press the START button to start the pump in the normal forward direction.
Pump Stop. Press the STOP button to stop the pump and de-energize the controller.
Caution! Always press the Pump Stop button and allow the pump to come to a
complete stop before pressing the Pump Reverse button.
Failure to let the pump stop before reversing may damage the pump and
drive.
Pump Reverse. Press the REVERSE button to start the pump in the reverse direction. Use
this feature to purge oil from the mold.
Vent Cycle Start. Press the VENT button to start the vent cycle timer. Use this feature to
purge air and water from the unit and process.