Brother PT-9700PC - Manual (Page 27)

27
Horizontal movement commands
CR Carriage return
[ASCII] CR
[Decimal] 13
[Hexadecimal] 0D
[Parameters] None
[Description]
・ Performs a line feed of the amount specified by a line feed command (ESC 0, ESC 2,
ESC 3 and ESC A).
・ If no line feed amount has been specified, it is automatically specified depending on the
width of the tape.
・ The next print position is the beginning of the next line.
・ A line feed command immediately after a carriage return is ignored.
ESC $ Specify absolute horizontal position
[ASCII] ESC $ n1 n2
[Decimal] 27 36 n1 n2
[Hexadecimal] 1B 24 n1 n2
[Parameters] 0≤n1≤255, 0≤n2≤255
[Description]
・ Specifies an absolute print position (in units of 1/60 inch) for the next data.
・ An absolute print position specifies the horizontal print position from the left margin.
・ The next character is printed at a position (n1 + 256 * n2) / 60 inch from the left margin.
* However, since the printable length is 1 meter, an actual value greater than 2362/60
inches will result in an error during printing