Brother PT-9700PC User Manual
Page 52
52
* 0 and 1 to 4 with Micro PDF417
7. Symbol size in Y direction
[1-byte decimal] 0
[1-byte decimal] 3 to 90
* 0 and 4 to 44 with MicroPDF417
Auto setting (default value)
Manual setting
8. Aspect
value
[2-byte decimal] 1 to 1000
Enter the aspect value. Actually, this is between 0.01 and
10.0. However, since a decimal point cannot be entered, a
value multiplied by 100 is entered.
The default is “50”.
(The actual value is 0.5.)
* Note:
・
The aspect value setting is ignored if the symbol size in the X direction or the symbol size
in the Y direction is entered manually.
・
Depending on the conditions, the bar code may not be generated or a bar code that
cannot be scanned may be generated if the symbol size in the X direction or the symbol
size in the Y direction is entered manually.
・
When a large cell size is specified together with a high error correction capacity, printing
may not be possible because the print buffer has become full.
[With symbol type Micro PDF417]
・
Since the error correction capacity is automatically determined from the symbol size in
the X direction, the settings for “Error correction capacity–type” and “Error correction
capacity–value” are ignored.
・
The aspect value setting is ignored.
The following table shows the values available for the symbol size in the Y direction
according to the symbol size in the X direction. If an invalid setting is specified for the
symbol size in the Y direction, the default setting is specified.
Symbol size in X
direction
Symbol size in Y direction
AUTO
AUTO
1
AUTO
11
14
17
20
24
28
2
AUTO
8
11
14
17
20
23
26
3
AUTO
6
8
10
12
15
20
26
32
38
44
4
AUTO
4
6
8
10
12
15
20
26
32
38
44
② Bar code data
The number of bar code data characters that can be entered is listed below.
1850 alphanumeric characters, 2710 numerals, 1108 bytes of binary data
* Note:
The number of characters that can be entered (listed above) is for when the error correction