Brother PT-9700PC - Manual (Page 58)

58
ESC i M 2D bar code (MaxiCode)
[ASCII] ESC i M data
[Decimal] 27 105 77 data
[Hexadecimal] 1B 69 4D data
・ Format
ESC i M [parameters] \ [bar code data] \\\
① ② ③ ④
① Parameters
If a value other than those listed is entered for a parameter, that parameter is set to its
default value.
1. Symbol type
[1-byte decimal] 0
[1-byte decimal] 1
[1-byte decimal] 2
Standard (default value)
Full EEC
Structured carrier message
2. Append mode
[1-byte decimal] 0
[1-byte decimal] 1
Structured append (default value)
Not appended
② \
Separator between parameters and bar code data
③ Bar code data
The number of bar code data characters that can be entered is listed below.
Maximum amount of information allowed Symbol type
Alphanumeric characters Numerals
Standard 93 138
Full EEC 77 113
Structured carrier message 84 126
* Note:
The number of characters that can be entered (as listed above) is for when only the
common character set (code set A in the MaxiCode specifications) is used. The number of