Brother CM100DM User Manual

Page 16

Advertising
background image

14

a

Peel off the protective sheet from the adhesive
side of the standard mat.

Note

Do not discard the protective sheet peeled off
the mat; save it for later use.

b

With the glossy side of the support sheet facing
down, attach it to the mat’s adhesive side.

Slowly attach the support sheet from its edges so that
no air is trapped between the mat and the sheet.

a Glossy side of support sheet

Note

Place the support sheet within the attaching
area (grid area) on the adhesive side of the mat.
If the sheet extends from the attaching area, it
may be damaged by the feed rollers when the
mat is fed.

c

Peel off the backing from the top of the support
sheet.

a Backing (light blue)
b Adhesive

d

Test attaching the material.

Before attaching the material to the mat, use a corner
of the adhesive side of the mat to test attaching it. If
any problems occur when testing attaching, use
different material.

e

From its edges, attach the material to the
adhesive side of the mat so that there are no
wrinkles in the material.

Be sure to first iron the fabric to remove any wrinkles.

Note

• Place the material within the attaching area

(grid area) on the adhesive side. If the material
extends from the attaching area, it may be
damaged by the feed rollers when the mat is
fed.

Memo

• The mat does not have a top and bottom. It can

be inserted into the feed slot from either end.

• Be sure that the vertical grain of the attached

fabric runs straight up and down. The built-in
patterns are automatically arranged suitable for
fabric with vertical grain.

• When drawing a seam allowance, attach the

fabric to the mat with its wrong side facing up.

f

Firmly move the spatula handle across the
surface of the fabric to remove any wrinkles
and firmly attach the fabric to the mat.

a

a

b

Advertising
This manual is related to the following products: