Brother CM100DM - Manual (Page 39)

37
3
d Touch in the layout editing screen.
• For details on the functions in the layout editing
screen, see “Layout Editing Functions” on page 35.
e Select , and then touch the “OK” key.
• Two pattern selection functions are available
depending on your preference.
For details on selecting multiple patterns, see
“Selecting Multiple Patterns” on page 31.
f Touch .
g Check the preview, and then touch the “OK”
key.
Note
• Welding pattern outlines cannot be undone. In
order to recreate the original pattern
arrangement, select the patterns again, and
then arrange them.
X The outlines of the selected patterns are welded.
Note
• This function welds the outermost outline of the
patterns. When welding certain types of
patterns that have inside areas cut out, the cut-
out areas are not used to create the outline. Be
sure that the welded patterns in the preview
area meet your wishes before completing the
procedure.
- Welding built-in characters
- Welding character images created by
scanning